In Mi-Forms Designer, on the Anoto configuration tab (File, Form Properties, Anoto), click on the Anoto pattern range that you are using, make sure the beginning pattern matches the Page 1 beginning pattern that you have printed.
For instance, in the screenshot below, the first pattern is 220.127.116.11 which corresponds to Page 1 (Instance 1)
18.104.22.168 = Page 2 (Instance 1)
22.214.171.124 = Page 3 (Instance 1)
126.96.36.199 = Page 4 (Instance 1)
It could be that your “Beginning Pattern” above is correct in that it starts with x.x.x.0 however your actual printed patterns might be associating
x.x.x.1 with Page 1
x.x.x.2 with Page 2, etc…
as your Page 1 ink is showing up on page 2.
If this is the case, there are two methods to resolve:
- Fix the printing so that prints start page 1 with x.x.x.0 instead of x.x.x.1.
- If the printing has already been completed in mass quantities, you should be able to adjust the Anoto settings for the form to start with x.x.x.1 and use that to create a new MFT.
Posted in: Digital Pens